Category: DXLOG RTTY MMTTY + 2Tone setup
Hits: 2672

RTTY Configuration for DXlog

Download DXlog free here http://dxlog.net/sw/ 

Support forum at groups.io https://groups.io/g/DXLog/ 

Usermanual Documentation http://dxlog.net/docs/index.php/Main_Page 

RTTY configuration

Settings for RTTY decoder types and paths to decoders

 

  1. Set the radio buttons for the correct RTTY decoder engine
  2. Set the paths to the relevant RTTY decoder engines
  3. Set tick box options as appropriate for your operation.

Number of decoders

Up to two decoders can be used per audio channel (radio). Set the path to each decoder, please note that the decoder for each radio must be in a separate folder on the PC hard drive.

Path for mmtty / 2Tone

Normal path for MMTTY is C:\ham\mmtty or c:\mmtty

Normal path for 2Tone could be c:\2Tone or c:\ham\2Tone\

SO2R operation and folders

If want to use multiple decoders or SO2R/SO3R ! Use own folder for radio 1 and radio 2.

For example c:\ham\radio1\mmtty and c:\ham\radio2\mmtty

DXlog supports SO2R with two computers

You can alternative use SO2R/SO2V or RUN/inband with two computers in network. Just enable network checked via wifi/wired/VPN hamachi and use the built in numberserver + having access to 4 VFO and 4 decoders.

 

Check Enable Network

The number server is activated in the Options|Configure network panel, described in configure network


Startnumberserver.png

in Settings for Network

 

 Options networking menu.png